现要求CJ1W-N参数 C+6(BIT 14)POSITIONING COMPLETED INPUT FLAG
定位完成后ON时间为50MSDRT2-OD16TA,请问在CXDRIVE软件中的PN4XX I/F MONITOR SETTING PARAME 中的PN433 POSITIONGING COMPLETION HOLD TIME
设为50DRT2-OD16TA,是否可以达到目的,如不行,要怎样设置,请教
Re: 时间: 2018/2/27 8:48:00
可以,PN432必须设定为3时,PN433设定才有效。
Re:Re: 时间: 2018/2/27 11:12:00
PN432设定为3时,有一句,the ON status will then be held until the next position command is received
是否不能达到定位完成后,C+6(bit 14)只ON 50ms 脉冲,请教!
Re:Re:Re: 时间: 2018/2/27 16:00:00
PN432设定为3时,有一句,the ON status will then be held until the next position command is received
是否不能达到定位完成后,C+6(bit 14)只ON 50ms 脉冲,请教!
Re:Re:Re:Re: 时间: 2018/2/27 18:24:00
PN342设定为3解释
Turn ON when there is no position command and the position error is equal to or lower than 6067 hex (Position window). Then, hold the ON state for the time set in 3433 hex (Positioning Completed Hold Time). After the Positioning Complete